Carrier Access Access Navigator user manual Set Gateway Address

Electrical Installation

Set Gateway Address

Set the Ethernet IP address and mask by typing the following line after the prompt, then press the Enter or Return key.

set ethernet ip address <address> <mask>

Example: set Ethernet address 192.168.118.65 255.255.255.0

To turn off Ethernet interface, enter

set ethernet ip address none

To display current settings, enter

show ip

Requirement: Access Navigator responds with correct IP address.

Set Gateway Address

NOTE: Gateway Address – A gateway is any device that passes packets from one network to another network in their trip across the Internet. Gateway addresses have the same format as IP addresses. If a gateway address is not used, you must enter none for the gateway address.

Set the gateway IP address by typing the following line after the prompt, then press the Enter or Return key.

set ip gateway <address>

If the gateway address is not used, enter

set ip gateway none

To display current settings, enter

show ip

Requirement: Access Navigator responds with correct gateway IP address.

Exit Management Session

NOTE: You will remain logged into the Access Navigator until you use the exit command.

When you are finished with the management session, you must log out and exit from the Access Navigator by entering the following command:

exit

Access Navigator - Release 1.8 August 2003 6-65