Carrier Access Access Navigator Set Remote V35 DSU, Set Remote V35 RxClock, Set Remote V35 Speed

CLI Language Reference

CLI Command List

Set Remote V35 DSU

Purpose: Determines if the Access Bank II V.35 interface will respond to standard V.54 Data Service Unit (DSU) loopcode patterns for payload loopbacks. When enabled (default setting), the interface will respond to loopup and loopdown codes. This permits remote testing of the V.35 data link up to the customer interface.

Security:	Level 2 (operator)
Syntax:	set	remote	<n> v35 dsu <offon>
Example:	set	remote	9 v35 dsu on

Field

n

off

on

Description

DS1 number, 1 to 32.

Disables DSU loopcode detection.

Enables DSU loopcode detection.

Set Remote V35 RxClock

Purpose: Sets the Access Bank II V.35 interface receive clock source to internal or external.

NOTE: Internal clock source timing is recommended. This setting prevents data slips by synchronizing the receive timing to the T1 interface.

Security: Level 2 (operator)

Syntax: set remote <n> v35 rxclk <intext>

Field

n

int

ext

Description

DS1 number, 1 to 32.

Set to internal clock source.

Set to external clock source

Example: set remote 9 v35 rxclk int

Set Remote V35 Speed

Purpose: Sets the DS0 data speed to either N￿56 Kbps (7-bit words) or N￿64 Kbps (8-bit words), where N is the number of DS0s assigned to the V.35 interface. The V.35 port is a synchronous interface, so both the speed and number of DS0s are required to calculate the clock rate. For example, if four DS0s are assigned, the N￿56 setting produces a rate of 224 Kbps. When N￿56 is selected, the V.35 interface inserts a zero into the least significant bit of the DS0 octet.

18-126 August 2003 Access Navigator - Release 1.8