Carrier Access Access Navigator user manual Normal

CLI Language Reference

CLI Command List

Table 18-2 Default Settings (Continued)

Parameter	Default	Comments
DS1 circuit identifier	CA DS1 #n	n = DS1 number
DS1 clock source	NORMAL	Uses system clock.
DS1 FDL protocol	NONE	Affects FDL out-of-band
		BOP loop code
		detection.
DS1 framing	ESF	Required for FDL
DS1 line loopback	DOWN	Disabled
DS1 line coding	B8ZS	Preferred for data
DS1 line buildout	1	DSX-1, 0-133 ft.
DS1 loop code detection	Drop DS1: OFF	Affects CSU in-band
	Groom DS1: ON	loop code detection.
	Switch DS1: ON	Drop side DS1s are
		normally disabled.
DS1 performance monitoring	0	Defaults to zero
thresholds		(disabled) for all
		threshold intervals and
		parameters
DS1 remote device management	NONE	Used to configure DS0
		remote management
DS1 send code	OFF
DS1 terminal ID	ds1 25 termid = 1	Ensures GR-303 primary
• GR-303 only	ds1 26 termid = 3	and secondary EOC and
	ds1 27 termid = 4	TMC are on different
	ds1 28 termid = 5	Quad DS1 Framer cards
	ds1 29 termid = 2	for protection.
	ds1 30 termid = 6
	ds1 31 termid = 7
	ds1 32 termid = 8
DS1 type
• DCS: DS1 1–32	DROP
• GR-303: DS1 1–24	DROP
• GR-303: DS1 25–32	SWITCH
DS1 up/down	UP
EOC primary	25:12	Follows DS1 term ID
EOC secondary	29:12	Follows DS1 term ID

18-60 August 2003 Access Navigator - Release 1.8