Provision Access Navigator

Set System ID or CLLI Code

Set System ID or CLLI Code

NOTE: The System Identifier (name, location, or Telcordia CLLI code) is a text string, such as “Acme Corp AN#2” or “DNVRCO1A201”. The identifier can be up to 20 characters long, and may use any combination of letters and numbers. The identifier must be enclosed in quote marks.

NOTE: The System Identifier also appears in the command line prompt. The default System Identifier is “Access Navigator” so the command prompt will be “Access Navigator>”. When you change the identifier, the prompt will also change. (If other management sessions are in progress, the operators will not see the new prompt until they start a new session.)

1. Show current System Identifier with the following command:

show id

2.If System Identifier is correct, skip remaining steps.

3.Set System Identifier with the following command: set id <"id">

Example: set id "DNVRCO1A201"

Access Navigator - Release 1.8

August 2003

8-5

Page 187
Image 187
Carrier Access Access Navigator user manual Set System ID or Clli Code, Show id