Carrier Access Access Navigator user manual Provision Remote Adit, Logon remote n

Provision Remote Adit 600 via FDL

Provision Remote Adit 600

Provision Remote Adit 600

1.Start remote management session with Adit 600 terminal, where <n> is the number of the Access Navigator drop DS1 going to the terminal.

logon remote <n>

Example: logon remote 10

2.When Adit 600 prompt appears, provision terminal using Adit 600 CLI commands (refer to Adit 600 User Manual.

3.When finished provisioning Adit 600 terminal, enter Ctrl+C to cancel the connection to the remote terminal. The Access Navigator prompt will then appear.

4.Exit management session when finished.

exit

Test DS1 and DS0 Circuits

NOTE: The Access Navigator can be pre-provisioned so that it will be ready to provide services when facilities become available. Therefore, it may be necessary to skip over the circuit testing steps in this procedure.

NOTE: The Access Navigator supports the following T1.403 loop tests:

•Responds to ESF bit patterned loop requests (when loopdetect is on)

•Generates ESF bit patterned loop requests

•Generates SF CSU inband loopcodes

NOTE: The Access Navigator provides line and payload loopback commands for troubleshooting line problems. See Diagnostics & Troubleshooting on page 15-1.

1.Follow standard practices to test subscriber drop DS1 circuits.

2.Follow standard practices to test DS0 connections, analog channels, and remote interfaces.

Access Navigator - Release 1.8 August 2003 12-17