Carrier Access Access Navigator Send Remote V35 TSI Loopup, Remote V.35 TSI Network Loopup

CLI Language Reference

CLI Command List

Send Remote V35 TSI Loopup

NOTE: This command applies only to a remote Access Bank II connected to the Access Navigator by a DS1 using Carrier Access FDL management protocol. For normal operation, the loopback must be disabled by the send remote loopdown command.

NOTE: Only one port of the Access Bank II can be looped up at a time. If a loopup command is received for a second port, the first port will be looped down automatically before the second port is looped up.

NOTE: To check remote loopback status, use the read remote loopback command. See Read Remote Loopback on page 18-51.

Purpose: Sends an out-of-band(FDL) message to a remote Access Bank II over the Access Navigator DS1. It is used to verify V.35 signal processing.

When the operator enters a send remote command, the Access Navigator transmits a message over the Carrier Access FDL management channel of the drop DS1. The Access Navigator’s drop DS1 is the Access Bank’s T1 connection.

The send remote v35 tsi network loopup command should cause the remote Access Bank II to perform a network loopback on the V.35 data. This takes the received V.35 DS0s from the DS1, loops them in the Time Slot Interchange (TSI), and sends them back to the DS1 output (see Figure 18-22).

The send remote v35 tsi equipment loopup command should cause the remote Access Bank II to perform an equipment loopback on the V.35 signal. This takes the received DS0s from the V.35 equipment interface, loops them in the Time Slot Interchange (TSI), and sends them back to the V.35 output (see Figure 18-23). To loopdown the interface, use the send remote loopdown command.

								V.35
CA FDL							TSI Network Loopup
Command
				Access Bank II
Access						Time Slot			Interface
	DS1	T1	Framer
Navigator
					Interchange

V.35

Figure 18-22. Remote V.35 TSI Network Loopup

Access Navigator - Release 1.8 August 2003 18-93