Carrier Access Access Navigator user manual DCS Provisioning Quick Guide

Provision DCS Service

DCS Provisioning Quick Guide

DCS Provisioning Quick Guide

CLI Commands	Descriptions
status equipment	Verify equipment configuration.
show ds1 <nall>	Verify service status.
status ds1 <n>
status ds0 <n:ch>
set ds1 <n> down	Set unused circuits out of service
set ds0 <n:ch> down	(down). If the DS1 is not terminated,
set ds0 <n:ch> type <voicedata>	set the DS0 type of all channels to
	data. If the DS1 is terminated, set the
	DS0 type of any unused channels to
	match the DS0 type (voice or data)
	configured on the device at the other
	end of the DS1.
set clock1 <bitsds1 ninternal>	Primary system clock source.
set clock2 <bitsds1 ninternal>	Secondary system clock source.
set ds1 <n> type <groomdrop>	DS1 type.
set ds1 <n> framing <d4esf>	DS1 framing.
set ds1 <n> linecode <amib8zs>	DS1 line code.
set ds1 <n> id <"id">	DS1 identifier.
set ds1 <n> clock <normalloop>	DS1 clock source.
set ds1 <n> lbo <setting>	DS1 line buildout.
set ds1 <n> loopdetect <onoff>	Usually off for drop DS1s.
show connect <n>	Verify DS0 crossconnections.
disconnect <n:ch>	Remove old DS0 connections.
set ds0 <n:ch> type <voicedata>	DS0 type (use data type for ISDN PRI
	passthrough).
set ds0 <n:ch> signal <lsgsem>	DS0 signaling (voice type only).
connect <n:ch> <n:ch>	Add DS0 crossconnections.
set ds0 <n:ch> up	Set DS0s in service.
set ds1 <n> up	Set DS1s in service.

9-6 August 2003 Access Navigator - Release 1.8