Carrier Access Access Navigator user manual 10-12

Provision GR-303 Service

Verify Service Status

NOTE: Commands containing ds1 <n> require the operator to enter a DS1 number or range of numbers. For example, DS1 #6 is entered as ds1 6. If a DS1 range is specified, the command operations will be applied to all DS1s in the range. To enter a range of DS1s, type the starting and ending numbers, separated by a hyphen. For example, DS1s #1 through #8 can be specified by typing ds1 1-8.

4.Show current DS1 status with the following command, where <n> is the DS1 or range of DS1s to be turned up:

status ds1 <n>

Example: status ds1 1

This command will produce a message listing the status of the specified DS1 or range of DS1s. For example, the message for DS1 #1 and #29 might look similar to the following. Note that the message for DS1 #1 shows the DS1 is in service, while the message for DS1 #29 indicates there is no Quad Framer circuit card installed.

Status for DS1 1:	Traffic
Receive:
Transmit:	Traffic
Loop:	None
State:	In Service
FDL Type:	None
Status for DS1 29:	Traffic
Receive:
Transmit:	Traffic
Loop:	None
State:	Card Not Installed
FDL Type:	None

5.Verify status of DS1 lines to be turned up by comparing DS1 status with office records. If there is a discrepancy, follow standard practices to resolve problem.

10-12 August 2003 Access Navigator - Release 1.8