Carrier Access Access Navigator Provision Groom DS0s to Adit Router, Set ds0 nch type data

Provision Remote Adit 600 via IP DS0

Provision Groom DS0s to Adit Router

Provision Groom DS0s to Adit Router

NOTE: Commands such as ds0 <n:ch> require the operator to enter both the DS1 and DS0 channel number or channel range. The DS1 and DS0 numbers are entered with a colon separating the numbers. For example, the channel list for DS1 #4 and DS0 channel #8 would be entered as ds0 4:8. The channel list may also contain a range of DS0 channels. For example, DS1 #6 and DS0 channels #1 through #12 would be entered as ds0 6:1-12. A colon follows the DS1 number, and the beginning and ending DS0 channels are separated by a hyphen.

1.Show current DS0 settings with the following command: show ds0 <n:ch>

Example: show ds0 32:1-4

The show command will produce a status message for each DS0 specified. For example, the mes- sage for DS1 number 32, DS0 channel 10 would look similar to the following:

Settings for DS1 32, Channel 10:

Type:	DATA
Signaling:	NONE
Up/Down:	UP
CRV:	320 (assigned but not available)
ISDN:	none

2.If groom DS0 settings are correct, skip remaining steps.

3.Set DS0 type to data for IP DS0 management

set ds0 <n:ch> type data

Example:	set ds0	32:6 type data
Example:	set ds0	32:1-24 type data

4. Set DS0 in service

set ds0 <n:ch> up

Example: set ds0 10:1-24 up

13-18 August 2003 Access Navigator - Release 1.8