Carrier Access Access Navigator user manual Show ID, Show Interface

CLI Language Reference

CLI Command List

Item	Description
Mask	The Access Navigator uses a subnet mask to identify the
	permissible range of addresses for each IP address. Large
	networks are usually divided into smaller subnetworks, each with
	an assigned range of IP addresses. Subnet masks have the format
	xxx.xxx.xxx.xxx, where each xxx is a decimal number
	between 0 and 255. Subnet masks usually start with one or more
	groups of 255. Typical examples include 255.255.0.0 and
	255.255.255.0. If a subnet mask is not used, type none or
	leave blank.
MAC Address	The Ethernet media access control (MAC) address is a
	hexadecimal number such as 00-E0-97-00-08-37.

Show ID

Purpose: Displays the System Identifier assigned to the Access Navigator. This is a name, location, or Telcordia (Bellcore) CLLI code. It is a text string, such as “Acme Corp. AN#2” or “DNVRCO1A201”. The System Identifier also appears in the command line prompt. The default System Identifier is “Access Navigator” so the command prompt will be “Access Navigator>”. When you change the identifier, the prompt will also change.

Security: Level 3 (monitor)

Syntax: show id

Message: ID: Access Navigator

Show Interface

Purpose: Displays the settings for one interface name, or for all interfaces defined for DS1s in the Access Navigator. Use the set interface command to change settings.

NOTE: CLI provides three commands for displaying DS1 interface

information: show interface, status interface, and read remote connect. The first displays provisioning information stored in the Access Navigator data base, while the second displays the current service status. The last command reads and displays current interface settings from the remote Access Bank II data base (see “Read Remote Connections” on page 18-48). Interface connections must be provisioned in the Access Navigator before the configuration settings can be downloaded to the remote Access Bank II.

Security: Level 3 (monitor)

18-146 August 2003 Access Navigator - Release 1.8