Carrier Access Access Navigator Set Time, Set TMC, Syntax set time hhmmss, Example set time

CLI Language Reference

CLI Command List

Set Time

Purpose: Set Access Navigator system clock time.

Security: Level 2 (operator)

Syntax: set time <hh:mm:ss>

Field	Description
hh:mm:ss	Time format is 24-hour clock in hours:minutes:seconds with
	colons to separate the digits, as in 08:30:45 and 15:22:10.
	Leading zeros can be omitted. The Access Navigator will update
	the time when it receives the command.

Example: set time 08:30:00

Example: set time 8:9:15

Set TMC

Purpose: This command sets the location of the primary and secondary TMCs on “switch” DS1s. GR-303 switch DS1s carry an Embedded Operations Channel (EOC) and Timeslot Management Channel (TMC) for call control. Primary and secondary EOC and TMC lines provide protection.

NOTE: For proper operation, the first switch DS1 (TermID = 1) in the GR- 303 interface group must contain the primary EOC and TMC. The second DS1 (TermID = 2) must contain the secondary EOC and TMC. By default, DS1 #25 is TermID 1 and DS1 #29 is TermID 2.

NOTE: It is recommended that primary and secondary EOC and TMC be assigned to different Quad T1 Framer (QF) cards for added protection. In the event one QF card fails, the GR-303 switch will then be able to continue service using the redundant EOC and TMC on a different QF card. QF card #1 contains DS1 #1 to #4, QF card #2 contains DS1 #5 to #8, etc. By default, the primary EOC and TMC are on DS1 #25 and the secondary EOC and TMC are on DS1 #29.

NOTE: A minor alarm will occur if the TMC is set to None.

Security: Level 2 (operator)

18-132 August 2003 Access Navigator - Release 1.8