Your First Session With The QuadraSynth Plus: Chapter 2

CHAPTER 2

YOUR FIRST SESSION WITH THE QUADRASYNTH PLUS

Powering Up

After making your connections, turn on the system’s power using this procedure:

¿Before turning on the QuadraSynth Plus’s power, check the following

items:

Have all connections been made correctly?

Are the volume controls of the amplifier or mixer turned down?

Is the volume of the QuadraSynth Plus turned down?

¡Turn on the [ON/OFF] (power) switch on the QuadraSynth Plus rear

panel.

Upon power-up, the QuadraSynth Plus will display the last selected Program or Mix. If this Program/Mix has been edited, the display will indicate this by showing the word “EDITED” below either the word “MIX” or “PROGRAM.”

¬Turn the QuadraSynth Plus’s master [VOLUME] control to maximum. The best signal-to-noise ratio is achieved when [VOLUME] is set to maximum. This is a digital volume control, and lower settings have lower resolution.

Turn on the power of the amplifier/mixer, and adjust the volume.

Adjusting the Display Contrast

Occasionally, the characters in the LCD display may be difficult to read, depending on the viewing angle and existing lighting conditions. In such a situation, adjust the contrast of the LCD display using the following procedure.

¿Press [GLOBAL].

The display will change to the Global Page.

¡Use Quad Knob [1] to adjust the contrast, or use the VALUE [¬] and [] buttons.

The contrast and its value in the display will change.

QuadraSynth Plus Piano Reference Manual

15

Page 14
Image 14
Alesis QuadraSynth Plus manual Your First Session with the Quadrasynth Plus, Powering Up, Adjusting the Display Contrast