Editing Programs: Chapter 6
Mod Wheel (-99 to 99)
This parameter sets how much the Mod Wheel will increase or decrease the Filter LFO’s Level. A positive value raises the level when the Mod Wheel is moved up, and lowers the level when moved down. Negative settings of this parameter will decrease the output level of the FLFO as the Mod Wheel is raised. Since the output level of the FLFO cannot be less than zero, a negative setting of the Mod Wheel parameter will have no effect unless either the Aftertouch or the Level is set to raise the FLFO output. If both the Level and Aftertouch are set to 00, and the Mod Wheel parameter is set to
Aftertouch (-99 to 99)
This is the modulation amount of Aftertouch over the Filter LFO’s Level. A positive value raises the level as more Aftertouch is applied. A negative value will lower the amount of FLFO level as more Aftertouch is applied.
Amp LFO
Amp LFO (Page 1)
The Amp LFO is usually used to add tremolo to a sound.
J
The Amp LFO variables will have an effect only if the AMP LFO DEPTH (in the AMP function) is set to a value other than 0 , or, if Amp LFO is a source in the MOD function.
Wave (8 choices)
The waveform determines the shape of the LFO. Use Quad Knob
[1]to select either Sine, Triangle, Square, Up Sawtooth, Down
Sawtooth,
Speed (00 to 99)
Quad Knob [2] controls the speed or rate of the LFO. For fast modulation, increase this value. For slower modulation, decrease this value.
Delay (00 to 99)
This is the amount of time that is to occur before the LFO fades in. Sometimes, it is desirable to have modulation come in a moment or two after a note has been played, rather than starting instantly. The higher the value, the slower the LFO fades in.
Trigger (Mono, Poly, Key Mono, Key Poly)
The Trigger parameter determines how the LFO should be triggered, or started. There are four possible settings: Mono,
QuadraSynth Plus Piano Reference Manual | 102 |
