AT-GS950/48PS Switch Web Interface User’s Guide
4.Under the Loopback Detection Global Settings, configure the following parameters:
Interval: This parameter sets the interval of time that the ports are tested. The range is 1 to 32767 seconds.
Recover Time: This parameter sets the amount of time that the port will take to recover once the loopback condition has been removed. The range is 60 to 1000000 seconds.
If the Recover Time is set to 0, the port recovery is disabled until it is manually reset. It can be reset by
5.Click the Apply button just above the Action column in the table at the bottom of the page.
The Loopback Detection Global Settings parameters becomes active.
6.In the table at the bottom of the page, select one of the Loopback Detection State choices from the pull down menu:
Ignore: This parameter indicates that the setting in the All row does not apply to the Loopback Detection State field. In other words, each port is set individually.
Enabled: This selection enables the Loopback Detection feature for each port. This state must be enabled along with the State field at the top of the page before this feature can be active on the selected port.
Disabled: This selection disables the Loopback Detection feature on the selected port.
Note
In the All row when you select Enable or Disable instead of Ignore, the selection applies to all of the
7.Click the Apply button in the Action column of the table.
8.Repeat steps 6 and 7 for other individual port settings.
9.From the main menu on the left side of the page, select Save Configuration to Flash to permanently save your changes.
