Allied Telesis AT-S111, AT-GS950/48PS manual Time Settings

Chapter 14: GVRP

Time Settings

Perform the following procedure to configure the GVRP port settings:

1.From the main menu on the left side of the page, select Bridge. The Bridge folder expands.

2.From the Bridge folder, select GVRP. The GVRP folder expands.

3.From the GVRP folder, select Time Setting.

A partial view of the AT-GS950/48PS GVRP Time Setting Page is displayed. See Figure 58.

Figure 58. AT-GS950/48PS GVRP Time Setting Page

Note

The GARPLeaveTimer must be greater than (GARPJoinTimer x2 +

10)and the GARPLeaveAllTimer must be greater than (GARPLeaveTimer + 10). The acceptable input values are multiples of 10. If you try to enter a value that is not a multiple of 10, the value is rounded down.

4.The following fields are listed for each port:

Port - This parameter displays the ports on the switch.

GarpJoinTime - This parameter is the GARP Join Timer. Its range is 10 - 1073741810 milli-seconds.

GarpLeaveTime - This parameter is the GARP Leave Timer. Its range is 30 - 2147483630 milli-seconds. This timer must be set in relation to the GVRP Join Timer according to the following equation:

GARPLeaveTimer >= (GARPJoinTimer X 2) + 10

172