Allied Telesis AT-GS950/48PS, AT-S111 manual User Interface Configuration

AT-GS950/48PS Switch Web Interface User’s Guide

User Interface Configuration

This procedure explains how to enable and disable the user interfaces on the switch. With this procedure you can enable or disable the AT-GS950/ 48PS SNMP Agent. For more information about SNMP, go to Chapter 16, “SNMPv1 and v2c” on page 189 and Chapter 17, “SNMPv3” on page 201.

Note

The Web Server Status is displayed as Enabled for your information only. The Web Server cannot be disabled.

SNMP Interface To enable or disable the AT-GS950/48PS SNMP interface, perform the following procedure:

1.From the main menu on the left side of the page, click the System folder.

The System folder expands.

2.From the System folder, select User Interface.

The User Interface Page is displayed. See Figure 10.

Figure 10. User Interface Page

3.Choose Enable or Disable from the pull down list for the SNMP Agent parameter.

Enabled - When you enable this parameter, the SNMP agent is active. You can manage the AT-GS950/48PS switch with Network Management Software and the switch’s private MIB.

Disabled - When you enable this parameter, the SNMP agent is inactive.

Note

See Chapter 16, “SNMPv1 and v2c” on page 189 and Chapter 17, “SNMPv3” on page 201 to configure the remaining SNMP parameters.

39