Allied Telesis AT-GS950/48PS, AT-S111 manual Upgrade Firmware Image via Tftp

AT-GS950/48PS Switch Web Interface User’s Guide

Upgrade Firmware Image via TFTP

This section describes how to upgrade an firmware image of the AT-S111 Management software using TFTP on an TFTP server. Before downloading a new version of the AT-S111 Management Software onto the switch, note the following:

The current configuration of a switch is retained when a new AT-S111 Management Software image is installed. To return a switch to its default configuration values, see “Configure Factory Default Values” on page 340.

Your network must have a TFTP server.

You must specify the path to the new AT-S111 image file on the TFTP server.

Start the TFTP server software before you begin the download procedure.

Caution

Downloading a new version of management software onto the switch causes the device to reset. Some network traffic may be lost during the reset process.

This procedure assumes that you have already obtained the software and have stored it on the computer from which you will be performing this procedure.

To download the AT-S111 image software onto the switch using a TFTP server, perform the following procedure:

1.From the menu on the left side of the home page, select the Tools folder.

This folder expands to show contents of the Firmware Upgrade folder.

2.From the Firmware Upgrade folder, select via TFTP.

The Firmware Upgrade via TFTP page is shown in Figure 127 on page 328.

327