AMX NXA-ENET24 manual Smtp Alert Commands, Command Function Show log Syntax

		CLI (Command Line Interface)
Event Logging Commands (Cont.)
Command	Function
show log	Syntax:
This command displays the	• show log {flash ram} [login] [tail]
system and event mes-	• flash - Event history stored in flash memory (i.e., permanent memory).
sages stored in memory.	• ram - Event history stored in temporary RAM (i.e., memory flushed on power
	reset).
	• tail - Shows event history starting from the most recent entry.
	• login - Shows the login record only.
	Default Setting: None
	Command Mode: Privileged Exec
	Command Usage: This command shows the system and event messages stored
	in memory, including the time stamp, message level, program module, function,
	and event number.
	Example: The following example shows sample messages stored in RAM:
	Console#show	log ram
	[5] 00:01:06	2001-01-01
	"STA root	change notification."
	level: 6,	module: 6, function: 1, and event no.: 1
	[4] 00:01:00	2001-01-01
	"STA root	change notification."
	level: 6,	module: 6, function: 1, and event no.: 1
	[3] 00:00:54	2001-01-01
	"STA root	change notification."
	level: 6,	module: 6, function: 1, and event no.: 1
	[2] 00:00:50	2001-01-01
	"STA topology change notification."
	level: 6,	module: 6, function: 1, and event no.: 1
	[1] 00:00:48	2001-01-01
	"VLAN 1 link-up notification."
	level: 6,	module: 6, function: 1, and event no.: 1
	Console#

SMTP Alert Commands

Configures SMTP event handling, and forwarding of alert messages to the specified SMTP servers and email recipients.

SMTP Alert Commands

Command	Function
logging sendmail host	Syntax:
This command specifies SMTP	[no] logging sendmail host ip_address
servers that will be sent alert	• ip_address - IP address of an SMTP server that will be sent alert
messages.	messages for event handling.
Use the no form to remove an	Default Setting: None
SMTP server.	Command Mode: Global Configuration
	Command Usage:
	• You can specify up to three SMTP servers for event handing. However,
	you must enter a separate command to specify each server.
	• To send email alerts, the switch first opens a connection, sends all the
	email alerts waiting in the queue one by one, and finally closes the
	connection.
	• To open a connection, the switch first selects the server that
	successfully sent mail during the last connection, or the first server
	configured by this command. If it fails to send mail, the switch selects
	the next server in the list and tries to send mail again. If it still fails, the
	system will repeat the process at a periodic interval. (A trap will be
	triggered if the switch cannot successfully open a connection.)
	Example:
	Console(config)#logging sendmail host 192.168.1.200
	Console(config)#

NXA-ENET24 - Software Management Guide 185