Address Table Settings
109
NXA-ENET24 - Software Management Guide
Address Table Settings
Overview
Switches store the addresses for all known devices. This information is used to route traffic directly between
the inbound and outbound ports. All the addresses learned by monitoring traffic are stored in the dynamic
address table. You can also manually configure static addresses that are bound to a specific port.

Setting Static Addresses

A static address can be assigned to a specific interface on this switch. Static addresses are bound to the
assigned interface and will not be moved. When a static address is seen on another interface, the address will
be ignored and will not be written to the address table.

Setting Static Addresses - Web

Click Address Table, Static Addresses. Specify the interface, the MAC address and VLAN, then click Add
Static Address.

Setting Static Addresses - CLI

This example adds an address to the static address table, but sets it to be deleted when the switch is reset.
Command Attributes
• Static Address
Counts:
The number of manually configured addresses.
Web Only
• Current Static
Address Table:
Lists all the static addresses.
• Interface: Port or trunk associated with the device assigned a static address.
• MAC Address: Physical address of a device mapped to this interface.
•VLAN: ID of configured VLAN (1-4094).
FIG. 112 Web -Configuring a Static Address Table
FIG. 113 CLI - Configuring a Static Address Table