AMX NXA-ENET24 manual Command Function, Show system Default Setting None

CLI (Command Line Interface)

System Status Commands (Cont.)

Command	Function
show running-config	vlan database
(Cont.)	vlan 1 name DefaultVlan media ethernet state active
	!
	!
	interface ethernet 1/1
	switchport allowed vlan add 1 untagged
	switchport native vlan 1
	.
	.
	.
	!
	interface vlan 1
	ip address DHCP
	!
	!
	no map IP precedence
	no map IP DSCP
	!
	!
	line console
	!
	line vty
	!
	end
	!
	Console#
show system	Default Setting: None
This command	Command Mode: Normal Exec, Privileged Exec
displays system	Command Usage: For a description of the items shown by this command, refer to
information.	“Displaying System Information” on page 3-9.
	The POST results should all display “PASS.” If any POST test indicates “FAIL,” con-
	tact your distributor for assistance.
	Example:
	Console#show system
	System description: 24FE Stackable Intelligent Switch
	System OID string: 1.3.6.1.4.1.259.6.10.61
	System information
	System Up time:	0 days, 0 hours, 0 minutes, and 7.18 seconds
	System Name:	[NONE]
	System Location:	[NONE]
	System Contact:	[NONE]
	MAC address:	5A-A5-AA-55-44-32
	Web server:	enabled
	Web server port:	80
	Web secure server:	enabled
	Web secure server port: 443
	Telnet server:	enable
	Telnet port:	23
	Jumbo Fram:	Disabled
	POST result
	POST result
	UART LOOP BACK Test..........PASS
	DRAM Test....................PASS
	Timer Test...................PASS
	PCI Device 1 Test............PASS
	PCI Device 2 Test............PASS
	Switch Int Loopback test.....PASS
	Done All Pass.
	Console#

NXA-ENET24 - Software Management Guide 191