AMX NXA-ENET24 manual Igmp Query Commands Layer 2, Ip igmp snooping query-interval Syntax

CLI (Command Line Interface)

IGMP Query Commands (Layer 2 - Cont.)

Command	Function
ip igmp snooping query-count	Syntax:
This command configures the query	ip igmp snooping query-count count
count.	no ip igmp snooping query-count
	• count - The maximum number of queries issued for which there has
Use the no form to restore the
	been no response before the switch takes action to drop a client from
default.
	the multicast group. (Range: 2-10)
	Default Setting: 2 times
	Command Mode: Global Configuration
	Command Usage: The query count defines how long the querier waits
	for a response from a multicast client before taking action. If a querier
	has sent a number of queries defined by this command, but a client has
	not responded, a countdown timer is started using the time defined by ip
	igmp snooping query-max- response-time. If the countdown finishes,
	and the client still has not responded, then that client is considered to
	have left the multicast group.
	Example: The following shows how to configure the query count to 10:
	Console(config)#ip igmp snooping query-count 10
	Console(config)#
ip igmp snooping query-interval	Syntax:
This command configures the query	ip igmp snooping query-interval seconds
interval.	no ip igmp snooping query-interval
	• seconds - The frequency at which the switch sends IGMP host-query
Use the no form to restore the
	messages. (Range: 60-125)
default.
	Default Setting: 125 seconds
	Command Mode: Global Configuration
	Example: The following shows how to configure the query interval to
	100 seconds:
	Console(config)#ip igmp snooping query-interval 100
	Console(config)#
ip igmp snooping query-max-	Syntax:
response-time	ip igmp snooping query-max-response-time seconds
This command configures the query	no ip igmp snooping query-max-response-time
	• seconds - The report delay advertised in IGMP queries. (Range: 5-25)
report delay.
	Default Setting: 10 seconds
Use the no form to restore the
default.	Command Mode: Global Configuration
	Command Usage: The switch must be using IGMPv2 for this command
	to take effect.
	This command defines the time after a query, during which a response
	is expected from a multicast client. If a querier has sent a number of
	queries defined by the ip igmp snooping query-count, but a client has
	not responded, a countdown timer is started using an initial value set by
	this command. If the countdown finishes, and the client still has not
	responded, then that client is considered to have left the multicast
	group.
	Example: The following shows how to configure the maximum
	response time to 20 seconds:
	Console(config)#ip igmp snooping query-max-response-time 20
	Console(config)#

NXA-ENET24 - Software Management Guide 273