AMX NXA-ENET24 manual System Defaults, Function Parameter Default

Introduction

System Defaults

The switch’s system defaults are provided in the configuration file “Factory_Default_Config.cfg.” To reset the switch defaults, this file should be set as the startup configuration file (See Downloading System Software from a Server section on page 34.) The following table lists some of the basic system defaults.

System Defaults

Function	Parameter	Default
Console Port Connection	Baud Rate	9600
	Data bits	8
	Stop bits	1
	Parity	none
	Local Console Timeout	0 (disabled)
Authentication	Privileged Exec Level	• Username “Admin”
		• Password “1988”
	Normal Exec Level	• Username “guest”
		• Password “guest”
	Enable Privileged Exec from Nor-	Password “super”
	mal Exec Level
	RADIUS Authentication	Disabled
	TACACS Authentication	Disabled
	802.1x Port Authentication	Disabled
	HTTPS	Enabled
	SSH	Enabled
	Port Security	Disabled
	IP Filtering	Disabled
Web Management	HTTP Server	Enabled
	HTTP Port Number	80
	HTTP Secure Server	Enabled
	HTTP Secure Port Number	443
SNMP	SNMP Agent	Enabled
	Community Strings	“public” (read only)
		“private” (read/write)
	Traps	Authentication traps: enabled
		Link-up-down events: enabled
	SNMP V3	View: defaultview
		Group: public (read only)
		private (read/write)

8 NXA-ENET24 - Software Management Guide