AMX NXA-ENET24 manual Command Function Show mac access-list Syntax

	CLI (Command Line Interface)
MAC ACL Commands (Cont.)
Command	Function
show mac access-list	Syntax:
This command displays the rules	show mac access-list [acl_name]
for configured MAC ACLs.	• acl_name – Name of the ACL. (Maximum length: 16 characters)
	Command Mode: Privileged Exec
	Example:
	Console#show mac access-list
	MAC access-list jerry:
	permit any host 00-e0-29-94-34-de ethertype 0800
	Console#
access-list mac mask-	Syntax:
precedence	[no] access-list ip mask-precedence {in out}
This command changes to MAC	• in – Ingress mask for ingress ACLs.
Mask mode used to configure	• out – Egress mask for egress ACLs.
access control masks.	Default system mask: Filter inbound packets according to specified MAC
Use the no form to delete the
	ACLs.
mask table.	Command Mode: Global Configuration
	Command Usage: You must configure a mask for an ACL rule before you
	can bind it to a port or set the queue or frame
	priorities associated with the rule.
	A mask can only be used by all ingress ACLs or all egress ACLs.
	The precedence of the ACL rules applied to a packet is not determined by
	order of the rules, but instead by the order of the masks; i.e., the first mask
	that matches a rule will determine the rule that is applied to a packet.
	Example:
	Console(config)#access-list mac mask-precedence in
	Console(config-mac-mask-acl)#

NXA-ENET24 - Software Management Guide 219