AMX NXA-ENET24 Configure Private Vlan Interfaces, Switchport private-vlan host Syntax Association

CLI (Command Line Interface)

Configure Private VLAN Interfaces

Configure Private VLAN Interfaces

Command	Function
switchport mode private-vlan	Syntax:
Use this command to set the private	switchport mode private-vlan {host promiscuous}
VLAN mode for an interface.	no switchport mode private-vlan
	• host – This port type can communicate with all other host ports
Use the no form to restore the default
	assigned to the same secondary VLAN. All communications
setting.
	outside of this VLAN must pass through a promiscuous port in the
	associated primary VLAN.
	• promiscuous – This port type can communicate with all other
	promiscuous ports in the same primary VLAN, as well as with all
	the ports in the associated secondary VLANs.
	Default Setting: Normal VLAN
	Command Mode: Interface Configuration (Ethernet, Port Channel)
	Command Usage: Promiscuous ports assigned to a primary VLAN
	can communicate with all other promiscuous ports in the same
	VLAN, as well as with all the ports in the associated secondary
	VLANs.
	Example:
	Console(config)#interface ethernet 1/2
	Console(config-if)#switchport mode private-vlan
	promiscuous
	Console(config-if)#exit
	Console(config)#interface ethernet 1/3
	Console(config-if)#switchport mode private-vlan host
	Console(config-if)#
switchport private-vlan host-	Syntax:
association	switchport private-vlan host-association secondary-vlan-
Use this command to associate an	id
	no switchport private-vlan host-association
interface with a secondary VLAN.
	• secondary-vlan-id - ID of secondary (i.e, community) VLAN.
Use the no form to remove this
	(Range: 2-4094, no leading zeroes).
association.
	Default Setting: None
	Command Mode: Interface Configuration (Ethernet, Port Channel)
	Command Usage: All ports assigned to a secondary (i.e., commu-
	nity) VLAN can pass traffic between group members, but must com-
	municate with resources outside of the group via a promiscuous port.
	Example"
	Console(config)#interface ethernet 1/3
	Console(config-if)#switchport private-vlan host-
	association 3
	Console(config-if)#
switchport private-vlan mapping	Syntax:
Use this command to map an interface	switchport private-vlan mapping primary-vlan-id
to a primary VLAN.	no switchport private-vlan mapping
	• primary-vlan-id – ID of primary VLAN.
Use the no form to remove this
	(Range: 1-4094, no leading zeroes).
mapping.
	Default Setting: None
	Command Mode: Interface Configuration (Ethernet, Port Channel)
	Command Usage: Promiscuous ports assigned to a primary VLAN
	can communicate with any other promiscuous ports in the same
	VLAN, and with the group members within any associated secondary
	VLANs.
	Example:
	Console(config)#interface ethernet 1/2
	Console(config-if)#switchport private-vlan mapping 2
	Console(config-if)#

NXA-ENET24 - Software Management Guide 261