AMX NXA-ENET24 manual Command Function Sntp poll Syntax, Default Setting 16 seconds, Show sntp

CLI (Command Line Interface)

Time Commands (Cont.)

Command	Function
sntp poll	Syntax:
This command sets	sntp poll seconds
the interval between	no sntp poll
	• seconds - Interval between time requests. (Range: 16-16384 seconds)
sending time	Default Setting: 16 seconds
requests when the
switch is set to	Command Mode: Global Configuration
SNTP client mode.	Example:
Use the no form to
	Console(config)#sntp poll 60
restore to the	Console(config)#
default.
show sntp	Command Mode: Normal Exec, Privileged Exec
This command	Command Usage: This command displays the current time, the poll interval used for
displays the current	sending time synchronization requests, and the current SNTP mode (i.e., unicast).
time and	Example:
configuration	Console#show sntp
settings for the	Current time:	Dec 23 05:13:28 2002
SNTP client, and	Poll interval:	16
indicates whether or	Current mode:	unicast
	SNTP status : Enabled
not the local time
	SNTP server 137.92.140.80 0.0.0.0 0.0.0.0
has been properly	Current server: 137.92.140.80
updated.	Console#
clock timezone	Syntax:
This command sets	clock timezone name hour hours minute minutes {before-utc after-utc}
the time zone for the	• name - Name of timezone, usually an acronym. (Range: 1-29 characters)
switch’s internal	• hours - Number of hours before/after UTC. (Range: 1-12 hours)
clock.	• minutes - Number of minutes before/after UTC. (Range: 0-59 minutes)
	• before-utc - Sets the local time zone before (east) of UTC.
	• after-utc - Sets the local time zone after (west) of UTC.
	Default Setting: None
	Command Mode: Global Configuration
	Command Usage: This command sets the local time zone relative to the Coordinated
	Universal Time (UTC, formerly Greenwich Mean Time or GMT), based on the earth’s
	prime meridian, zero degrees longitude. To display a time corresponding to your local
	time, you must indicate the number of hours and minutes your time zone is east (before)
	or west (after) of UTC.
	Example:
	Console(config)#clock timezone Japan hours 8 minute 0 after-UTC
	Console(config)#
calendar set	Syntax:
This command sets	calendar set hour min sec {day month year month day year}
the system clock. It	• hour - Hour in 24-hour format. (Range: 0-23)
may be used if there	• min - Minute. (Range: 0-59)
is no time server on	• sec - Second. (Range: 0-59)
your network, or if
	• day - Day of month. (Range: 1-31)
you have not
	• month - january february march april may june july august september
configured the
	october november december
switch to receive
	• year - Year (4-digit). (Range: 2001-2100)
signals from a time
server.	Default Setting: None
	Command Mode: Privileged Exec
	Example: This example shows how to set the system clock to 15:12:34, April 1st, 2004:
	Console#calendar set 15 12 34 1 April 2004
	Console#

188 NXA-ENET24 - Software Management Guide