AMX NXA-ENET24 manual Command Function Ping Syntax

CLI (Command Line Interface)

IP Interface Commands (Cont.)

Command	Function
ping	Syntax:
This command sends	ping host [size size] [count count]
ICMP echo request	• host - IP address or IP alias of the host.
packets to another	• size - Number of bytes in a packet.
node on the network.	(Range: 32-512, default: 32)
	The actual packet size will be eight bytes larger than the size specified because the
	switch adds header information.
	• count - Number of packets to send. (Range: 1-16, default: 5)
	Default Setting: This command has no default for the host.
	Command Mode: Normal Exec, Privileged Exec
	Command Usage: Use the ping command to see if another site on the network can
	be reached.
	Following are some results of the ping command:
	• Normal response - The normal response occurs in one to ten seconds, depending
	on network traffic.
	• Destination does not respond - If the host does not respond, a “timeout” appears in
	ten seconds.
	• Destination unreachable - The gateway for this destination indicates that the
	destination is unreachable.
	• Network or host unreachable - The gateway found no corresponding entry in the
	route table.
	Press <Esc> to stop pinging.
	Example:
	Console#ping 10.1.0.9
	Type ESC to abort.
	PING to 10.1.0.9, by 5 32-byte payload ICMP packets, timeout is 5
	seconds
	response time: 10 ms
	response time: 10 ms
	response time: 10 ms
	response time: 10 ms
	response time: 10 ms
	Ping statistics for 10.1.0.9:
	5 packets transmitted, 5 packets received (100%), 0 packets lost (0%)
	Approximate round trip times:
	Minimum = 10 ms, Maximum = 20 ms, Average = 10 ms
	Console#

NXA-ENET24 - Software Management Guide 277