AMX NXA-ENET24 manual General Commands, Disable Default Setting None

CLI (Command Line Interface)

Line Commands (Cont.)

Command	Function
show line	Syntax:
This command	show line [console vty]
displays the terminal	• console - Console terminal line.
line’s parameters.	• vty - Virtual terminal for remote console access (i.e., Telnet).
	Default Setting: Shows all lines
	Command Mode: Normal Exec, Privileged Exec
	Example: To show all lines, enter this command:
	Console#show line
	Console configuration:
	Password threshold:	3 times
	Interactive timeout:	Disabled
	Login timeout:	Disabled
	Silent time:	Disabled
	Baudrate:	9600
	Databits:	8
	Parity:	none
	Stopbits:	1
	VTY configuration:
	Password threshold:	3 times
	Interactive timeout:	600 sec
	Login timeout:	300 sec
	console#

General Commands

General Commands

Command	Function
enable	Syntax:
This command	enable [level]
activates Privileged	• level - Privilege level to log into the device.
Exec mode.	The device has two predefined privilege levels: 0: Normal Exec, 15: Privileged Exec.
	Enter level 15 to access Privileged Exec mode.
	Default Setting: Level 15
	Command Mode: Normal Exec
	Command Usage: “super” is the default password required to change the command
	mode from Normal Exec to Privileged Exec. (To set this password, see the enable pass-
	word command.)
	The “#” character is appended to the end of the prompt to indicate that the system is in
	privileged access mode.
	Example:
	Console>enable
	Password: [privileged level password]
	Console#
	In privileged mode, additional commands are available, and certain commands display
	additional information. See the Understanding Command Modes section on page 162.
disable	Default Setting: None
This command	Command Mode: Privileged Exec
returns to Normal	Command Usage: The “>” character is appended to the end of the prompt to indicate
Exec mode from	that the system is in normal access mode.
privileged mode.	Example:
	Console#disable
	Console
	In normal access mode, you can only display basic information on the switch's configura-
	tion or Ethernet statistics. To gain access to all commands, you must use the privileged
	mode. See the Understanding Command Modes section on page 162.

NXA-ENET24 - Software Management Guide 169