Apex Digital K1106 installation instructions Arming reports to the central station

Display Open at Keypad: Used to show when specified zones are open. Typically, all internal zones (PIR's, Smoke

	Detectors) are not programmed to show status at the keypad. This prevents constant
	STATUS light flashing. External zones (windows, doors) should be programmed to show
	status so the user is updated to all perimeter changes. Zones that are programmed not to
	show open at the keypad are not included in the monitor mode, unless extended monitor
	is used. This programming option does not affect opening (disarming) and closing
	(arming) reports to the central station.
Duration Between	The length of time the system pauses before saying "Entry Detected." The shortest time
Pre-alarm Cycles:	period is three seconds (000). Any value in this location is added to the default 3
	seconds.
Duress:	When this option is enabled, the user code will issue a silent duress code to the central
	station.
Duration Between Fire,	For zone trouble, transmitter tamper, or a fire zone trouble condition, a supervisory beep
Tamper, Trouble Chirps:	will be sounded at intervals determined by this time. For all activations except the fire
	chirp, the tone can be silenced by checking status. Valid times are from 1 to 255
	seconds. If a value of 000 is programmed, this feature is disabled. This feature must be
	enabled in a UL installation
Duration for Recognition	For systems with a back up battery, the system can determine when AC power is lost.
of AC Power Loss:	This location determines the time period in minutes before the system will recognize the
	power loss and speak "POWER OFF." If the communicator is programmed, it will send a
	report to the central station. Valid AC power loss recognition times are from 1 to 255
	minutes. This feature must be enabled in a UL installation
Echo Communicator:	To listen to the communicator transmission through the inside speaker, enter 9960 while
	in program mode. Each communication will be heard over the inside speaker. When
	testing is complete, return to programming mode and enter 9960 to turn off the
	communicator monitor feature. Communicator monitor automatically turns off when the
	panel is turned off or when the two-way voice circuit becomes active. Whenever
	possible use the communicator monitor feature instead of a telephone butt set. The
	panel’s phone circuit is very sensitive to loading. A good test to attempt when
	experiencing communicator difficulties is to remove all connections from R1 and T1 and
	connect only the panel to R and T. This ensures a good phone connection and can help
	isolate troublesome connections.

Echo local Phone Speech: When local (in house) phones are used as keypads, system speech is typically only heard through the phone. With this option selected, system speech will be heard through the inside speaker as well as the phone.

Enable Night mode:	With this option selected, the system can be placed into Night mode. When the system
	is armed to HOME, press the H or # key. When armed to Night mode, both the AWAY
	and HOME LED's on the keypad will be lit, the entry delay doors become instant and
	interior delay #2 zones are active. To exit Night mode, disarm or press the H or # key to
	return to HOME mode.

45