Apex Digital K1106 installation instructions Using This Manual, Control Board Loop

Example:

Options - Enter Total

Using This Manual:

Automated Locations: Automated Location prompt for specific information and automatically record the

appropriate information into the correct locations.

Value Locations:A documented location that contains a specific value (i.e. time, user number, etc.)

Option Location:Most system options require a total of option values to be placed in a location.

Location Value

Speak auxiliary zone type ............................................................................................. 001

Speak status immediately after local phone access ....................................................... 002

Silence inside speaker in HOME/Night mode (Not permitted in a UL installation) ....... 004

Speak zone description in Extended Monitor ................................................................ 008

Disable force arming (For UL installations this option must be enabled) ....................... 064

Default 0078 ................... 009

The bold 001 and 008 state the values are included in a defaulted panel. To include the 3rd option, add 004 and enter the total (013) in location 0078. If no options were selected, enter 000.

Charts:	Charts are used to provide a large number of locations in a small space. Depending
	on how the section is used, the locations in charts contain either an option value or
	a discrete value.

Example:
Options	Value

2 end-of-line resistor supervision .................................................................................. 064

No end of line resistor (Not permitted in a UL installation) ........................................... 128

Default (1 end-of-line resistor) ..................................................................................... 000

Zone 1

Input	Control Board Loop 1
Option	Locatio n	Default	New Value
Zone Type	0647	255
Option 1	0643	080
Option 2	0644	000
Supervision	1106	000
Word 1		Word 3
Word 2		Word 4

The title at the top of the chart refers to the system zone number. The Input type (Control Board Loop 1) refers to hardware type. Below the Option heading are the locations for Zone 1. To program the zone for 2 end-of-line resistor supervision, enter 1106,064. Each location referenced above is shipped with the values found in the default column.

18