4. Replace the right panel mounting bracket on the display panel with two screws.
5.Replace the left bracket on the display panel with two screws.
6.Connect the two
7.Turn over the panel. If the lower EMI shield was removed, reattach the lower EMI shield across the bottom of the panel.
8.Position the panel into the rear housing. Make sure the inverter cable and the LVDS cable are accessible and not tucked under the panel.
9.Secure the panel with four T10 mounting screws.
10.Connect the inverter cable connector to the logic board.
11.Connect the LVDS cable connector to the logic board and secure it with two T6 screws.
12.Fold the EMI tape firmly over the left, top, and right edges of the display panel. Use the black stick to adhere the tape firmly and rub out wrinkles.
13.Replace the lower EMI shield.
14.Replace the front bezel.
15.Replace the access door.
