Asante Technologies FR3000 Series Dial-up Log for Dial-Up Network, COM2 is in console mode

Error	Cause
-303, -304	PPTP server rejects outgoing call request.
-332	Outgoing call not established – general error.
-333	Outgoing call failed due to no carrier detected.
-334	Outgoing call failed due to detection of a busy signal.
-335	Outgoing call failed due to lack of a dial tone.
-336	Outgoing call was not established within time allotted by PAC.
-337	Outgoing call administratively prohibited.

F.6 Dial-up Log (for Dial-Up Network)

1.“COM2 is in console mode”.

The COM port is in console mode. In general, the router will detect the existence of the modem. If there is a modem attached, the COM port is available for dial- up service immediately. Action: wait a moment or reboot the router.

2.“COM2 start to dial-up”. The router started to dial-up.

3.“COM2: baud=115200”.

The baud rate to communicate with the modem was 115200.

4.“DIAL2: tx ATZ”.

The router sent “ATZ” string to the attached modem or ISDN TA.

5.“DIAL2: rx OK”.

The router received “OK” string from the attached modem or ISDN TA.

6.“COM2 start to hang-up”. The router started to hang-up.

User’s Manual 79