ATEN Technology KL9108, KL9116 user manual Multiuser Operation, Rule

KL9108 / KL9116 User Manual

Multiuser Operation

The KL9108 / KL9116 supports multiuser operation. Up to 32 users can log in at the same time. When multiple users simultaneously access the KL9108 / KL9116 switch from remote consoles, the rules of precedence that apply are shown in the following table:

Operation	Rule
General	Once a user invokes the OSD, no other user can invoke it until
	the original user closes it.
Auto Scan Mode	If a user has invoked Auto Scan Mode (see page 68), but the
	OSD has not been invoked, another user can interrupt Auto
	Scan Mode by invoking the OSD.
Panel Array Mode	Š When a user has invoked Panel Array Mode (see page 70),
	all successive users automatically enter Panel Array Mode.
	Panel Array Mode continues until the original user stops it.
	(Administrators can override Panel Array Mode.)
	Š Only the user who starts Panel Array Mode can use the Skip
	Mode (see page 69) function.
	Š Only the user who starts Panel Array Mode can switch ports.
	Other users automatically switch to the ports that the original
	user selects. However, if an individual user does not have
	access rights to the port that the original user switches to,
	the user will not be able to view that port.
	Š Individual users can increase or decrease the number of
	panels they wish to view in Panel Array Mode; however, the
	picture quality may decrease as the number of panels
	decreases.

Note: ATEN recommends that the user who starts Panel Array Mode set it to display at least four panels; otherwise, it is possible that other users may receive only part of the picture.

72