
|
| Chapter 1. Introduction |
|
|
|
|
|
|
|
|
|
No. | Component | Description |
|
|
|
5 | Keyboard | Standard |
|
|
|
6 | Keyboard | These catches (one on each side) release the keyboard/ |
| Release Catch | touchpad module so you can slide it away. |
|
|
|
7 | Touchpad | Standard mouse touchpad |
|
|
|
8 | Lower Handle | Pull to slide the keyboard/touchpad module out. (See Basic |
|
| Operation, page 19, for more details on sliding the console in |
|
| and out.) |
|
|
|
9 | Rack Mounting | The rack mounting tabs located at each corner of the unit |
| Tabs | secure the chassis to a system rack. (See Standard Rack |
|
| Mounting, page 13, for details.) |
|
|
|
10 | LCD Release | These catches (one on each side) release the LCD module |
| Catch | so you can slide it away. |
|
|
|
11 | LCD On/Off | Press this button to turn the LCD monitor on and off. When |
| Button | the LCD monitor is off, this button illuminates; when the LCD |
|
| monitor is on, this button does not illuminate. (This function |
|
| only affects the monitor, not the KVM switch itself.) |
|
|
|
12 | Lock Key & Status | The NUM LOCK, CAPS LOCK, SCROLL LOCK, LINK, and |
| LEDs | 10/100 Mbps LEDs are located here. The NUM LOCK, |
|
| CAPS LOCK, and SCROLL LOCK LEDs function exactly as |
|
| those on a standard keyboard. The LINK LED flashes when |
|
| a remote client connects to the KVM switch. The 10/100 |
|
| Mbps lights orange to indicate 10 Mbps data transmission |
|
| speed, and green for 100 Mbps. |
|
|
|
13 | External Mouse | You can use this port to connect an external PS/2 mouse. |
| Port |
|
|
|
|
14 | Port Selection | The UP and DOWN buttons are used to select ports. Press |
| Buttons | the DOWN button (left) to move down through the ports; |
|
| press the UP button (right) to move up through the ports. |
|
|
|
15 | Reset Switch | A reset switch is located just to the left of the port selection |
|
| buttons. |
Pressing and holding this switch in while powering on the KL9108 / KL9116 makes the switch use the factory installed firmware version rather than the firmware version that the switch has been upgraded to.
This allows you to recover from a failed firmware upgrade and gives you the opportunity to try upgrading the firmware again.
Pressing and holding this switch in for more than three seconds performs a system reset.
Note: This switch is recessed and must be pushed with a thin object - such as the end of a paper clip or a ballpoint pen.
9