ATTO Technology 2500C operation manual Diagnostic commands

7.1.4 Diagnostic commands

ATTO iPBridge diagnostic commands help validate iPBridge operation and diagnose or isolate iPBridge faults. Event logging is a mechanism for on-site observation of internal iPBridge behavior such as tracing SCSI commands received over the GbE from the host and return of data and status to the host.

BridgeModel

Reports model information about a specific iPBridge

Get syntax: get BridgeModel

BridgeName

Specifies name used to identify individual iPBridge units. May be up to a maximum of eight characters. It is not the World Wide Name (WWN).

Set syntax: set BridgeName [value]

Takes effect immediately

Get syntax: get BridgeName

ClearEventLog

Clears the contents of the event log. No events are recorded until the command has been completed.

Immediate command: ClearEventLog

ClearTraceLog

Clears the contents of the trace log. No events are recorded until the command has been completed.

Immediate command: ClearTraceLog

DisplayEventLog

Displays the most recent page of event log entries. Typing a +, - or = causes the next, previous or same page of event log entries to be displayed. No events are recorded until the command has been completed. Type <escape> to disable the command, begin new log entries, and return to CLI.

Immediate command: DisplayEventLog < + - = q>

43

DisplayEventLogFilter

Filters the display of data for specific iPBridge subsystems when in DisplayEventLog mode. If enabled for a particular subsystem and level, that subsystem and level is masked when the command DisplayEventLog is issued.

Subsystem entries:	Log level entries:
SCSI	INFO
ENET	WARN
GEN	CRIT
NVRAM	FAIL
PERF	ALL
ECC
ALL
HTTP
iSCSI

NDMP Default: disabled

Set syntax: set DisplayEventLogFilter [subsystem] [level] [enableddisabled]

Get syntax: get DisplayEventLogFilter [subsystem] [level]

DisplayTraceLog

Displays the most recent page of trace log entries. Typing a +, - or = causes the next, previous or same page of trace log entries to be displayed. No events are recorded until the command has been completed. Type <escape> to disable the command, begin new log entries, and return to CLI.

Immediate command: DisplayTraceLog < + - = q>

DisplayTraceLogFilter

Filters the display of data for specific iPBridge subsystems when in DisplayTraceLog mode. If enabled for a particular iPBridge port, that port is masked when the command DisplayTraceLog is issued.

Default: disabled

Set syntax: set DisplayTraceLogFilter [ndmp scsi all] [dp sb all] [enabled disabled]

Get syntax: get DisplayTraceLogFilter [ndmp scsi all ] [dp sb all ]

ATTO Technology Inc. iPBridge Installation and Operation Manual