Ping
Sends an ICMP echo request to the specified host.
Immediate command: Ping [DPn MPn] [xxx.xxx.xxx.xxx] <count <size>>
RMON
RMON collects and stores Ethernet data on data ports at specified intervals. You can display the entire table requested, or a single entry based on the index (and sample index for the Ethernet History table).
Entries in the Ethernet History table are not valid when their Sample Index is 0.
Setting the history control entries take effect immediately, but changes must be saved to be persistent over a reboot.
Valid range for EthernetStat index:
Valid range for historyControl and EthernetHistory index:
Valid range for historyControl buckets requested: 1- 180
Valid range for historyControl interval:
Set syntax: set RMON idx buckets Request interval [valid invalid]
Get syntax for entire table: get RMON [ethernetStat historyControl] <idx>
Get syntax for single index entry: get RMON ethernetHistory <idx sampleIdx>
RouteDisplay
Displays a list of host protocol to SCSI address mappings on the bridge.
For NDMP, displays a list of NDMP name to SCSI Bus, Target, LUN mappings. The optional name parameter limits the list to the maps which satisfy a search for the given name.
NumEntries: decimal number of map lines displayed
Name:
type: NDMP map type, either Tape or SCSI
sb: decimal SCSI bus number
st: decimal SCSI target number
sl: decimal SCSI LUN number
Immediate command: RouteDisplay NDMP <Name>
For iSCSI:, displays a list of iSCSI to SCSI Bus, Target, LUN mappings. If Multiple Target mode has been enabled, the optional Target Name parameter limits the list to the maps which satisfy a search for the given target name. In either mode, the optional LUN parameter limits the list to the map which satisfies a search for the given LUN.
NumEntries: decimal number of map lines displayed
Target Name: target name
Lun : target LUN
sb: decimal SCSI bus number
st: decimal SCSI target number
sl: decimal SCSI LUN number Immediate command, single target mode: RouteDisplay iSCSI <lun>
Immediate command, multiple target mode: RouteDisplay iSCSI <Target Name> <lun>
SCSIPortList
Returns a list of available SCSI ports and their current status. Valid status returns are O.K. and Failed.
Immediate command: SCSIPortList
SCSITargets
Returns a list of SCSI devices operational on the referenced SCSI port.
Immediate command: SCSITargets [sb]
SerialNumber
Reports the serial number which is unique for each iPBridge. The serial number tracks the board throughout its life and should not be changed for any reason. Set form requires operator privileges.
Information only: get SerialNumber
SNMPDumpMIB
Dumps the contents of the ATTO FibreBridge private SNMP MIB to the current CLI session. Consult your network administrator for further assistance with SNMP.
Immediate: SNMPDumpMIB
SNMPExtendedTraps
Controls Extended SNMP map functioning such as device transition and device error. Consult your network administrator for further assistance with SNMP.
Set syntax: set SNMPExtendedTraps [enableddisabled]
Get syntax: get SNMPExtendedTraps
45
ATTO Technology Inc. iPBridge Installation and Operation Manual
