ATTO Technology operation manual Atto iPBridge 2500C, Height of tallest component .535 inches

1.2 ATTO iPBridge 2500C

The ATTO iPBridge 2500C is a 1-Gigabit Ethernet to SCSI embeddable cPCI bridge for high performance, cost effective solutions in enterprise environments.

The iPBridge 2500C includes two Ethernet data ports, an Ethernet management port which may be used as a data port in the iPBridge 2500 iSCSI- configured model, a serial management port and two SCSI ports. It includes a battery-backed Real- Time-Clock, and an IP Time client (RFC 1631 compliant).

Dimensions

Width: 6.193 inches

Length: 6.375 inches

Height of tallest component: .535 inches

Environment

Operating Temperature: 0-70°C external

Ambient air should not exceed 40°C.

User-configurable thermal sensor for automatic

shutdown default is 70°C Humidity: 10-90%non-condensingRecommended airflow: 11 cubic feet per minute

Power

The iP2500C board may be powered from the cPCI backplane or a 6-pin connector.

Input voltage: 5.0V DC ±5% derived from cPCI or 6-pin connection. Fused at the backplane and hot swap protection.

Power draw: 3 amps at 5.0V DC. Battery-backed

event log SRAM: A rechargeable Lithium ion battery cell or Super Cap holds the memory in a 512KB SRAM based on the following chart.

Recharging begins automatically when power is restored to the system.

	Time to charge	Backup power
	battery or CAP	duration
Battery	36 hours	30 days
(typical)	continuous power
Super CAP	60 seconds	3 hours
worst case
Super CAP	>320 seconds	5-15 hours
typical

WARNING

Risk of explosion if the battery is removed and/or replaced by an incorrect type. Dispose of used batteries in accordance with your local environmental regulations.

SCSI interface

The two independent SCSI ports on the iPBridge 2500C connect storage devices into the Ethernet Storage Area Network (SAN). Each port is completely independent.

The ports are Ultra 3 LVD/SE SCSI busses with 68-pin “P” interface: 160 MB/sec. maximum throughput, downward compatible with all forms of single-ended SCSI.

The iPBridge supports all SCSI devices including hard disk drives, tape drives, RAID controllers and DVD, MO and CD libraries.

Ethernet interface

The two independent 10/100/1000 GbE RJ45 data ports, labeled Ethernet port 0 and Ethernet port 1, use the Intel 8254x family gigabit Ethernet chipset to support telnet-based data transfer. A separate 10/100/1000 Ethernet standard RJ45 management port, labeled Ethernet port 2 and which may be used as a data port in the iPBridge 2500 iSCSI-configured model, provides monitoring and management through ATTO ExpressNAV, a browser-based interface.

6 Installation: ATTO iPBridge 2500C