7.1.7 Ethernet commands

These commands configure the management and data Ethernet ports including telnet parameters.

DPMTU

Controls the MTU (Maximum Transmission Unit) used by the Ethernet ports: Increasing the MTU may improve throughput.

Default: 1514

Set syntax: set DPMTU [DPn MPn all] [1514 9014 16128]

Requires a SaveConfiguration command Get syntax: get DPMTU [DPn MPn all]

IPDHCP

Selecting DHCP allows the iPBridge to request an IP address from the network DHCP server. The network must have at least one DHCP server.

Default: enabled

Set syntax: set IPDHCP [DPn MPn all] ] [enabled disabled]

Requires a SaveConfiguration command Get syntax: get IPDHCP [DPn MPn all]

EthernetSpeed

Specifies the speed of the Ethernet ports. If auto is enabled, the speed is negotiated. Speeds 10 and 100 are half duplex If you want to run the iPBridge at 10baseT, you must set the Ethernet speed using this command..

Choices are

10 = 10 baseT

100 = 100 baseT

1000 =1000baseT Default: auto

Set syntax: set EthernetSpeed [DPn MPn all ] [10 100 1000 Auto]

Requires a SaveConfiguration command

Get syntax: get EthernetSpeed [DPn MPn all]

Exit

Exits the current telnet CLI session; it has no effect if used during a serial CLI session.

Immediate command: Exit

IPGateway

Controls the current gateway. If IPDHCP is enabled (see above), get command reports the current IP gateway assigned by the network DHCP server.

Default: 0.0.0.0

Set syntax: set IPGateway [DPn MPn all] xxx.xxx.xxx.xxx

Requires a SaveConfiguration command Get syntax: get IPGateway [DPn MPn all]

IPSubnetMask

Controls the current subnet mask. If IPDHCP is enabled (see above), get command reports the current subnet mask assigned by the DHCP server.

Default: 255.255.0.0

Set syntax: set IPSubnetMask [DPn MPn all] xxx.xxx.xxx.xxx

Requires a SaveConfiguration command

Get syntax: get IPSubnetMask [DPn MPn all]

IPAddress

Controls the IP address of the iPBridge Ethernet data ports. If IPDHCP is enabled, the get command reports the current IP address assigned by the network DHCP server, followed by the DHCP identifier.

Default IP addresses: [10.0.0.1] [10.0.0.2] [10.0.0.3]

Set syntax: set IPAddress [DPn MPn] xxx.xxx.xxx.xxx Requires a SaveConfiguration command

Get syntax: get IPAddress [DPn MPn all]

Password

Specifies a password for all sessions: NDMP, telnet, FTP and ExpressNAV web-based interface. A prompt asks for the current password, to enter the new password, and to confirm the new password. Passwords are case sensitive, 0-32 characters with no spaces. An empty password can be configured by entering the Password confirmation prompts with no parameters. The command RestoreConfiguration default sets the password to its default value.

Default: Password

Set syntax: set Password

Requires a SaveConfiguration command

51

ATTO Technology Inc. iPBridge Installation and Operation Manual

Page 60
Image 60
ATTO Technology 2500C operation manual Ethernet commands