3.1 ExpressNAV pages
Each page in the ATTO ExpressNAV interface provides information and/or configuration parameters based on a specific topic. Each page can be reached through the menu at the side of each page. An image on each page’s header shows each port in the product faceplate. Each port is clickable and takes you to the appropriate page.
Status
Displays iPBridge information:
•Vendor ID, product ID, firmware revision number and serial number
•Valid temperature range, current temperature and current voltage
•Ethernet port IP addresses and status
Serial Port Configuration
Configures the baud rate and echo parameters. Refer to Serial port configuration commands on page 49 for details on each option.
Time & Date Configuration
Configures the
•Enable/disable Simple Network Time Protocol
•Time Server and time zone
•Manually set time and manually set date
Refer to Maintenance commands on page 41 for details each parameter.
Ethernet Port Configuration
Configures each port independently for the following parameters:
•Enable/disable DHCP
•IP address, gateway, subnet mask and Ethernet speed
•MTU
For NDMP configurations only
•NDMP max. version and NDMP port number
Refer to Getting an IP address on page 10, NDMP commands on page 53 and Ethernet commands on page 51 for details.
SCSI Configuration
Configures each port independently for the following parameters:
•Bus speed
•Enable/disable sync transfer
•Enable/disable wide transfer
•Initiator ID
•Enabled/disable bus reset on startup
•Enable/disable bus termination
Attached devices are listed for each bus and you can reset each port from this screen.
Refer to SCSI configuration commands on page 47.
iSCSI Configuration
Defines the iSCSI CHAP target name, account name and secret and configures the following parameters:
•iSCSI Alias
•iSCSI Port Number
•Enable/disable iSNSLoginControl
•Enable/disable Multi Target Mode
•Enable/disable SpeedWrite
•Enable/disable CHAP settings: direction (in or out)
Refer to iSCSI commands on page 55 for details on each parameter.
Bridge Configuration
Defines a name for the bridge, sets an admin user name and password, a read only user name and password, restores defaults or configures the following parameters:
•Minimum and maximum operating temperature
•Operating temperature warning
•Enable/disable Identify Bridge
For NDMP configurations only
•NDMP authorization type
Refer to Maintenance commands on page 41 for details on each parameter.
Mapping
Maps drives. If in Multiple Target mode in an iSCSI model, you may choose, add or delete an iSCSI target. Refer to Mapping devices: NDMP on page 13, Mapping devices: iSCSI on page 15, and Mapping commands on page 57 for details.
Advanced CLI Configuration
Allows you to input any CLI command available through the iPBridge. See Exhibit
1Type in the CLI command
2Click the Submit button.
23
ATTO Technology Inc. iPBridge Installation and Operation Manual
