Section 1
General Information

Programming & Operation 4-11MN715

Security System Access Timeout Parameter Change
Action Description Display Comments
Apply Power Keypad Display shows this
opening message. Logo display for 5 seconds.
If no faults and programmed for
LOCAL operation. Display mode. Stop LED on.
Press PROG key Enter program mode.
Press or key Scroll to Level 2 Blocks.
Press ENTER key Access Level 2 Blocks.
Press or key Scroll to the Security Control
block.
Press ENTER key Access the Local Security block.
Press key Scroll to the Access Timeout
parameter.
Press ENTER key Attempt to access the Access
Timeout parameter. represents blinking cursor.
Press key Use key to change value.
Example: 8999. Note: Ignore the 5 digit number to
the right (example: 23956).
Press ENTER key Save Access Code parameter Security code entered is correct.
All parameters may be changed.
Press SHIFT key. Move cursor right one digit. Access Timeout can be any value
between 0 and 600 seconds.
Press key 3 times Change the 0 to 3. Example: 30 seconds.
Press ENTER key Save value. P: will change to L: after you
return to Display mode for longer
than the time specified in the
Access Time parameter.
Press DISP key Return to Display mode. Typical display mode.

Note: Please record your access code and store it in a safe place. If you cannot

gain entry into parameter values to change a protected parameter, please

contact Baldor. Be prepared to give the 5 digit code located on the lower right

side of the Keypad Display at the Enter Code prompt.