Avaya P330-ML-ML Ip access-default-action, Router-N#access-default-action 101 default-action-deny

Chapter 2 Avaya P330-ML Layer 2 CLI Commands

ip access-default-action

User level: supervisor

This command applies to the P334T-ML only when it is in device mode "Layer2".

Use the ip access-default-actioncommand to set the default action for a specific policy list.

The syntax for this command is:

ip access-default-action <policy-list-number> <default- action>

<policy-list-number> integer (100...149)

<default-action>default-action-denydefault-action-permit

Example:

Router-N#access-default-action 101 default-action-deny

Done!

ip access-list-dscp operation

User level: supervisor

This command applies to the P334T-ML only when it is in device mode "Layer2".

Use the ip access-list-dscp operation command to set a DSCP to CoS mapping. The system performs the mapping for only those frames than match an ACL rule with a ‘permit’ action.

The syntax for this command is:

ip access-list-dscp operation <policy-list-number> <dscp> <action>

policy- A valid id number for a policy list currently defined for the module

list- (100..149) number

dscp DSCP value or range of DSCP

Avaya P330-ML Reference Guide 39