
Chapter 3
Avaya P330-ML Layer 3 CLI Commands
This chapter provides all the Layer 3 CLI (Command Line Interface) commands, parameters, and their default values.
How the Layer 3 CLI is Organized
The commands that make up the Layer 3 CLI are organized alphabetically and according to context.
Router Configuration Contexts
You can either use the general Layer 3 commands available from the Router(configure)# prompt or you can enter one of two router configuration context modes:
Router interface context
Allows you to define parameters individually for each interface. To enter this context, type interface <interface_name>
The prompt changes to Router-N(config-if:<interface_name>)#
Router protocol context
Allows you to define parameters for a specific routing protocol (RIP, OSPF, and SRRP). To enter this context, type router <protocol_name>
The prompt changes to
To exit these context modes, type the command exit.
Shortcuts to Commands by Context
Command descriptions are organized into the following contexts:
General Commands | Page 212 |
Interface context Commands | Page 274 |
Router RIP context Commands | Page 291 |
Router OSPF context Commands | Page 293 |
Router SRRP context Commands | Page 296 |
Avaya | 211 |