Chapter 2 Avaya P330-ML Layer 2 CLI Commands
show boot bank
User level: privileged, supervisor.
This command is not supported by the P333R and
Use the show boot bank command to display the software bank from which the switch will boot at the next boot process.
You must issue this command separately for each switch in the stack using the session command.
If you wish to run this command on a switch other than the stack master, you need to open a session to the relevant switch.
The syntax for this command is:
show boot bank
Example:
P330-N>show boot bank
Boot bank set to
show cam
User level: user, privileged, supervisor
Use the show cam command to either display the module and port number where a specific MAC address was learned, or the MAC addresses learned on a specific module and port.
MACs associated with LAGs appear under the LAG ID, not under the LAG port.
The syntax for this command is:
show cam [module[/port]]
module | Number of the switch. If you do not specify a number, all |
(Optional) | switches in the stack are shown. |
port | Number of the port on the module. If you do not specify a |
(Optional) | number, all ports on the specified switch are shown. |
Avaya | 131 |
