Avaya P330-ML-ML manual P330-N#set ppp incoming timeout, Set psu type, P330-N#set psu type DC

Chapter 2 Avaya P330-ML Layer 2 CLI Commands

Example:

P330-N#set ppp incoming timeout 15

PPPincoming session will automatically disconnect after 15 minutes of idle time

set psu type

User level: privileged, supervisor.

Use the set psu type command to set the main power supply type (AC/DC) of the module.

This command is not applicable to P330-ML-ML switches, which determine the PSU type automatically. This command is used to set the power supply types for other P330-ML switches in the stack.

The syntax for this command is:

set psu type [ACDC][module number]

Example:

P330-N#set psu type DC 3

Power supply type was changed to DC on module 3

set qos policy-source

User level: supervisor

This command applies to the P334T-ML only when it is in device mode "Layer2".

Use the set qos policy-sourcecommand to set the policy source (local or policy server).

The syntax for this command is:

set policy source <source>

source	local or policy server
	• The default policy source for the P334T-ML switch is local
Example:

P330-N#set qos policy-source local

Done!

108 Avaya P330-ML Reference Guide