Avaya P330-ML-ML manual Set device-mode, Router-Nset device-mode Layer2

Chapter 3 Avaya P330-ML Layer 3 CLI Commands

switchrouteratmmgpwan	(optional) The entity to which you want to
	open a session.
	If you do not specify this parameter, you will
	get the default entity of the specific module:
	switch - Layer 2 entity of the switch (see Note
	below).
	router - Routing entity.
	atm - ATM entity.
	mgp - Media Gateway Processor.
	wan - WAN access router entity.

When you use the session command the security level stays the same.

Example:

Router-1> session 2

Router-2>

The security level stays the same when you use the session command.

set device-mode

User level: privileged, supervisor.

Use the set device-modecommand to change the basic mode of operation of the switch between Router and Layer 2 modes.

This command is available on P330-ML-ML and P333R switches only.

The syntax for this command is:

set device-mode <mode>

mode Router Layer2

Example:

Router-N>set device-mode Layer2

This command will RESET the device

*** Reset *** - do you want to continue (Y/N)? y

Avaya P330-ML Reference Guide 243