Avaya P330-ML-ML manual Set port powerline, P330-N#set port powerinline 3/1-3 enable

Chapter 2 Avaya P330-ML Layer 2 CLI Commands

set port powerline

User level: privileged, supervisor.

This command applies to P333T-PWR switches only and is used by P330- ML-ML switches to control P333T-PWR modules in the stack.

Use the set port powerinline command to enable or disable the load detection process and power delivery for the port.

The syntax for this command is:

set port powerinline <module_number/port_number> {[enable]

disable}
module_	Number of the module hosting the port for which load detection is to
number	be enabled/disabled.
port_	Number of the port for which load detection should be
number	enabled/disabled.
	enable - enables load detection process for port
	disable - disables load detection process for port
Example:

P330-N#set port powerinline 3/1-3 enable

Load detection process on ports 3/1-3 is enabled

set port powerline priority

User level: privileged, supervisor.

This command applies to P333T-PWR switches only and is used by P330- ML-ML switches to control P333T-PWR modules in the stack.

Use the set port power inline priority command to configure the priority level of powering the port. Possible values are Critical, High, and Low. At power on all ports are set to Low Priority.

Within each group, the lowest port number has a highest priority, i.e. within the ports 1 to 8, port 1 has the highest priority although its priority is lower than port 9 which belongs to High priority group.

The syntax for this command is:

set port powerinline priority <module_number/port_number> <priority>

module_number	Number of the module hosting the port for which a
	powerline priority level is to be set.
port_number	Number of the port for which a powerline priority level is
	to be set.

Avaya P330-ML Reference Guide 97