Avaya P330-ML-ML manual Show port, P330-Nshow port 3/4

Chapter 2 Avaya P330-ML Layer 2 CLI Commands

show port

User level: user, privileged, supervisor

Use the show port command to display port status.

The syntax for this command is:

show port [<mod_num>[/port_num]]

mod_num	Number of the switch. If you do not specify a number, the ports
(Optional)	on all the switches are shown.
port_num	Number of the port on the module (can be a vitrual LAG port
(Optional)	number). If you do not specify a number, all the ports on the
	switch are shown.
	You can also specify a range of ports separated by a dash, for
	example, 4/5-13 for ports 5 to 13 on switch 4.

Example: to display the status for port 4 on switch 3

P330-N>show port 3/4
Port	Name	Status	Vlan Level		Neg	Dup. Spd. Type
------	--------------- ---------		---- ------		-------	---- ----	-----------------
3/4	Gregory	no link	1	0	enable	half 10M	10/100BaseTx Port
Show Port Output Fields
Field		Description
Port		Switch and port number
Name		Name of port
Status		Status of the port (connected, no link, disabled)
Vlan		VLAN ID of the port
Level		Priority level of the port (0-7)
Neg		The autonegotiation status of the port (enabled, disabled)
Dup		Duplex setting for the port (full, half)
Speed		Speed setting for the port (10Mbps, 100Mbps, 1000Mbps)
Type		Port type, for example:

•10/100Base-Tx, 1000Base-SX Port, Link Aggregation Group of 10/100Base-T ports

158 Avaya P330-ML Reference Guide