Avaya P330-ML-ML manual Network, Redistribute

Chapter 3 Avaya P330-ML Layer 3 CLI Commands

Router RIP Context

You can only access these commands in the “Router-RIP” context.

Type router rip at the command prompt to enter the “Router-RIP” context if necessary.

network

User level: privileged, supervisor.

Use the network command to specify a list of networks on which the RIP is running.

Use the no network command to remove an entry.

The syntax for this command is:

[no] network <ip-address> [<wildcard-mask>]

ip addr	The IP address of the network of directly connected networks
wildcard-mask	Wildcard mask address. Exists for compatibility with P550.

Example:

To specify that RIP will be used on all interfaces connected to the network 192.168.37.0:

Router-N(configure router:rip)# network 192.168.37.0

Done!

redistribute

User level: privileged, supervisor.

Use the redistribute command to redistribute routing information from other protocols into RIP.

Use the no redistribute command to disable redistribution by RIP.

The default is disabled.

The syntax for this command is:

[no] redistribute <protocol>

protocol Either Static or OSPF

Avaya P330-ML Reference Guide 291