Avaya P330-ML-ML manual Set port channel

Chapter 2 Avaya P330-ML Layer 2 CLI Commands

<module>/<port> {no-flowcontrolasym-tx-onlysym-onlysym-and-

asym-rx}
module	Number of the module.
port	Number of the port on the module. If you do not specify a
	number, all the ports on the module are set. Alternatively,
	you can specify a range of ports separated by a dash, for
	example, 4/5-13 for ports 5 to 13 on module 4.
no-flowcontrol	The port will advertise no pause capabilities.
asym-tx-only	The port will advertise asymmetric Tx pause capabilities only.
sym-only	The port will advertise symmetric pause capabilities only.
sym-and-asym-rx	The port will advertise both symmetric and asymmetric Rx
	pause capabilities.
Example:

P330-N#set port auto-negotiation-flowcontrol- advertisement 1/5 asym-tx-only

Port 1/5 pause capabilities was set

set port channel

User level: privileged, supervisor.

Use the set port channel command to enable or disable a Link Aggregation Group (LAG) interface on the switch. LAG creation requires a LAG name to be specified. There is no default name.

You can also add or remove a port from an existing LAG. When adding or removing a port to an existing LAG, type the same LAG-name. All ports in the LAG are configured with the parameters of the first port that is added to the LAG. These parameters include port administrative status, speed, duplex, autonegociation mode, VLAN ID, tagging mode, binding mode, and priority level.

The ports added to a LAG must belong to the same LAG group - refer to the “LAG” marking on device’s front panel.

When adding a port to an existing LAG, type the same LAG name, otherwise you will create a new LAG.

84 Avaya P330-ML Reference Guide