Avaya P330-ML-ML manual Set trunk 3/3 dot1q, Set utilization cpu module-number

Chapter 2 Avaya P330-ML Layer 2 CLI Commands

set trunk

User level: privileged, supervisor.

Use the set trunk command to configure the VLAN tagging mode of a port.

set trunk <module/port> {offdot1q}

module	Number of the switch.
port	Number of the port on the switch.
	You can also specify a range of ports separated by a dash,
	for example, 4/5-13 for ports 5 to 13 on switch 4.
off	Forces the port to become a non-tagging port.
dot1q	Specifies an IEEE 802.1Q tagging on a Fast Ethernet or
	Gigabit Ethernet port.
Example:
P330-ML-1#	set trunk 3/3 dot1q

Dot1Q VLAN tagging set on port 3/3.

set utilization cpu

User level: privileged, supervisor.

Use the set utilization cpu command to enable CPU utilization monitoring on the specified module.

The syntax for this command is:

set utilization cpu <module-number>

module-	The module number for which CPU utilization monitoring is
number	enabled.
Example:

P330-N#set utilization cpu 1

CPU utilization is set on module 1

Done!

Avaya P330-ML Reference Guide 125