Avaya P330-ML-ML manual Snmp-server enable volatile, P330-Nsnmp-server enable

Chapter 2 Avaya P330-ML Layer 2 CLI Commands

snmp-server enable

User level: supervisor

Use the snmp-servercommand to enable SNMP Access to the switch.

The syntax for this command is:

snmp-server enable [volatile]

volatile By default the activation of the snmp-server command is

(Optional) permanent and automatically stored in the non-volatile memory. The SNMP server is automatically launched after all restarts. If the volatile parameter is provided, then the SNMP service runs only until the stack is reset.

Example:

P330-N>snmp-server enable

Done!

snmp-server enable notifications

User level: supervisor

Use the snmp-server enable notifications command to enable sending all Simple Network Management Protocol (SNMP) notifications (traps and informs).

The syntax for this command is:

snmp-server enable notifications

Example:

P330-N>snmp-server enable notifications

Done!

snmp-server engineID

User level: supervisor

Use the snmp-server engineID command to change the SNMP Engine ID. Only the default user can run this command.

Avaya P330-ML Reference Guide 201